cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|
625
Views
0
Helpful
0
Replies

dot1x on c1121X-8P

tmlakar
Level 1
Level 1

Dear Cisco Experts

We have recently purhchased new Cisco C1121X-8P routers to replace ageing C891F-K9. I have sucessfuly transfer/transform old configuration to the new one with match C1121 port layount and new sw features. However one is still on todo list. DOT1X. I was not able to configure it. I have folow official Cisco guidelines, however there are not dot1x commands available on GigabitEthernet0/1/* ports.

My old config on Gi ports is:

interface GigabitEthernet1
description Svetlana
switchport access vlan 21
no ip address
no logging event link-status
authentication event fail action next-method
authentication host-mode multi-domain
authentication order mab dot1x
authentication priority dot1x mab
authentication port-control auto
mab
no snmp trap link-status
dot1x pae authenticator
dot1x timeout quiet-period 3
dot1x timeout tx-period 3
dot1x max-reauth-req 3
spanning-tree portfast

I have even check on GUI, but either there no DOT1X features are not available.

Any thaughts or ideas where to check and look?

0 Replies 0