doubt with fex active-active configuration

[knack81]

Hi, 

i have a pair of nexus 5548 with a pair of nexus 2232 configured in active-active mode (each n2k are connected to each n5k with  2 interfaces port-channel)

so my question is that, the interface configuration of fex interfaces are not synced? so if i modify the confing about n2k's ports on one n5k i need to manualy do the same config on other n5k?

i ask because i configure an interface on fex102 and on other nexus the same port of the fex102 has default config.

thanks

Andrea

[Giuseppe Larosa]

Hello @knack81 ,

you can take advantage of Fabric Services over IPv4 to keep in sync the configuration.

see

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus2000/sw/configuration/guide/n9k_rel_703I11/b_Cisco_Nexus_2000_Series_NX-OS_Fabric_Extender_Configuration_Guide_for_Cisco_Nexus_9000_Series_Switches_Release_7x/b_Cisco_Nexus_2000_Series_NX...

both for new deployment and for an already existing deployment

Warning: the config guide is for Nexus 9000 and FEX, it should apply also to Nexus 5548.

Hope to help

Giuseppe

[balaji.bandi]

so my question is that, the interface configuration of fex interfaces are not synced? so if i modify the confing about n2k's ports on one n5k i need to manualy do the same config on other n5k?

yes the configuration need to be configured both the side, if the device FEX is dual homed - this is general practice.

check the config as below :

https://www.balajibandi.com/?p=663