04-06-2020 02:54 AM
hi team,
i have problem with an port in nexus 3K connected to an equipement work in 10 mb and full duplex
i put under the port the config:
int eth 1/7
sw mo acc
sw acc vlan X
duplex full
speed 10
but the port always work in half duplex and is not stable
please some one help me ?
thanks
04-06-2020 03:06 AM
- How do you identify 'not stable' 2) Does your device use full-duplex when connected to another switch-platform and does it then remain stable?
M.
04-06-2020 03:12 AM
04-06-2020 03:44 AM
- What happens if auto-defaults are used for duplex and speed-settings (no directives in the port-configuration) ? Especially after doing so , disconnect and connect the device again to the port , then after 30 secs issue the command show logging on the switch. Is there any additional info ?
M.
04-06-2020 04:32 AM
04-06-2020 09:34 AM
- Some suggestions 1) Use another network cable or if you are using patch infrastructure , make a direct connection if possible (to exclude cabling issues) 2) Depending on the type of this device check it's low level network settings and or it's network card. Check if there are related speed and duplex settings which can correlate with the needed connectivity on the nexus.
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide