cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
269
Views
10
Helpful
2
Replies

EEM to bounce ports

Adam-USA
Beginner
Beginner

Hi,

I want to use EEM code to bounce ports of two switches, but the code I have bounce only the first switch ports.

event manager applet port_bounce authorization bypass

event none sync yes maxrun 240

action 0010 set switch "1"

action 0020 cli command "enable"

action 0030 cli command "config t"

action 0040 while switch le 2

action 0060  set port "1"

action 0070  if $port le "5"

action 0080   cli command "interface Gi$switch/0/$port"

action 0090   cli command "shutdown"

action 0100   wait 5

action 0110   cli command "no shutdown"

action 0120   increment port 1

action 0130  else

action 0135   increment switch 1

action 0140  end

action 0145 end

!

I appreciate any help!

 

1 Accepted Solution

Accepted Solutions

Dan Frey
Cisco Employee
Cisco Employee

Place the "set port 1" outside the while loop.   port variable keeps getting set to 1 at each iteration.

View solution in original post

2 Replies 2

Dan Frey
Cisco Employee
Cisco Employee

Place the "set port 1" outside the while loop.   port variable keeps getting set to 1 at each iteration.

Adam-USA
Beginner
Beginner

Thank you Dan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers