erase bootvar

[saravanababu22]

friends,

look into the below info

============

BOOT variable = ,1;s3223-entservicesk9_wan-mz.122-18.SXF8.bin,1;bootdisk:s3223-e

ntservicesk9_wan-mz.122-18.SXF8.bin,1;bootdisk:s3223-entservicesk9_wan-mz.122-18

.SXF8.bin,1;

CONFIG_FILE variable =

BOOTLDR variable does not exist

Configuration register is 0x2102

=========

what does this "BOOT variable = ,1" refer to, how to clear this boot var statement. i need to point it to single image followed by 1.

i want the output to be configured as

MSFC(boot)# show boot

BOOT variable = s3223-entservicesk9_wan-mz.122-18.SXF8.bin,1

CONFIG_FILE variable does not exist

BOOTLDR variable = bootflash:s3223-entservicesk9_wan-mz.122-18.SXF8.bin

Configuration register is 0x2102

kindly guide me

[Edison Ortiz]

It's all part of the boot system command. Please refer to the documentation:

http://www.cisco.com/en/US/docs/ios/fundamentals/command/reference/cf_a1.html#wp1015403

HTH,

__

Edison.

[Yudong Wu]

"BOOT variable = ,1" refer to command "boot system flash".

Type "sh run | i boot system" to see what boot statement in the current config. And then remove unused boot command. Then "wr mem" and check "show boot" again.

[ullasupendran]

In your case remove the existing boot system commands and try the following one.

boot system flash:s3223-entservicesk9_wan-mz.122-18.SXF8.bin

boot system bootldr bootflash:s3223-entservicesk9_wan-mz.122-18.SXF8.bin

I assumed that the bootloader you mentioned in the output is correct.

Hope to help

Ullas