Error-disabled uplinks Core switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-28-2012 05:15 PM - edited 03-07-2019 09:43 AM
By a customer of my I had a problem that the uplink of core switches are going to error-disabled state when connecting a Cisco switch to the existing network.
Here is a overview of our netwerk.
I connected the Cisco 3560 switch to a HP switch (ASC2). The configuration of the uplinks on the Cisco switch and the HP switch are the same as the connection to HP switch (EBG01) that is connected to the Cisco 4500 switch (Core).
On the Cisco 3560 switch I give the command "no ip routing".
Can anyone tell me what was the reason why the uplinks of the core switch that is connected to EBG01 are going to error-disable state? In de log I only see that the ports are going to error disable stat but without a reason.
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-28-2012 06:44 PM
The only way to determine is to run the command "sh int status err" and it'll tell you the reason.
I am suspecting it's BPDU guard.
