Error port disable

[fauzan0resmal]

Hi,

My C2960-16PS-LL port always disable. This port connect to access point AIR-AP280 via gig0/1.

Error:

10/24/2022 10:05:59 AM Error 32: Interface GigabitEthernet0/15, changed state to up
10/24/2022 10:05:59 AM Error 33: Interface GigabitEthernet0/16, changed state to up
10/24/2022 10:05:59 AM Error 41: Interface GigabitEthernet0/2, changed state to up
10/24/2022 10:05:59 AM Error 29: Interface GigabitEthernet0/1, changed state to up
10/24/2022 10:05:59 AM Error 34: Interface GigabitEthernet0/2, changed state to up
10/24/2022 10:05:59 AM Error 40: Interface GigabitEthernet0/1, changed state to up
10/24/2022 10:05:59 AM Error 44: Interface Port-channel1, changed state to up
10/24/2022 10:05:59 AM Error 30: Interface GigabitEthernet0/10, changed state to up
10/24/2022 10:05:59 AM Error 38: Interface GigabitEthernet0/2, changed state to down
10/24/2022 10:05:59 AM Error 37: Interface GigabitEthernet0/1, changed state to down
10/24/2022 10:05:59 AM Error 31: Interface GigabitEthernet0/11, changed state to up
10/24/2022 9:53:58 AM Error 1466: Interface GigabitEthernet0/11, changed state to down
10/21/2022 9:59:29 AM Error 1463: Interface GigabitEthernet0/1, changed state to up
10/21/2022 9:59:26 AM Error 1462: Interface GigabitEthernet0/1, changed state to down
10/21/2022 9:59:21 AM Error 1459: Interface GigabitEthernet0/1, changed state to up
10/21/2022 9:56:17 AM Error 1456: Interface GigabitEthernet0/1, changed state to down
10/21/2022 9:56:15 AM Error 1454: A packet storm was detected on Gi0/1. The interface has been disabled.

Config C2960-16PS-LL:

interface GigabitEthernet0/1
switchport access vlan 187
switchport mode access
no snmp trap link-status
storm-control broadcast level bps 1m
storm-control multicast level bps 1m
storm-control action shutdown
storm-control action trap
spanning-tree portfast edge
spanning-tree bpduguard enable

-----------------------------------

Please advice best practice to solve this error.

[marce1000]

 - Remove the storm-control directives from the interface configuration because they are too strong, the interface may already get disabled on 1Mb/s traffic passing (!)

 M.

[fauzan0resmal]

Do you have any suggestion if still want to use storm-control?

[balaji.bandi]

Error 1454: A packet storm was detected on Gi0/1. The interface has been disabled.

based on the message, what suggested strom configure, remove and test it.

i was wondering, why other ports aslo getting going up and down, is that has same config?

[fauzan0resmal]

for other port, yes the config is same. 

[MHM Cisco World]

share 
show interface 
show etherchannel summary