12-17-2012 01:04 PM - edited 03-07-2019 10:39 AM
Dears
Would like your assistance please regarding ES20+ QoS
As I understand for these cards QoS is MQC; i.e. similar to that of normal WAN cards
1- If i have 7600 with ES+ card only then I dont need to configure global command "mls qos" and the concept of trust boundries "mls qos trust dscp" will not exist , correct ?
||||
2- For below output, why "show mls qos queuing" is giving an O/P similar to that of WS-X6xxx LAN modules
Also why it is WRR when scheduling is not configured
I expected that command will not work with this module as it is similar to WAN modules
7606-1#sh mls qos queuing in gi1/5
Weighted Round-Robin
Port QoS is enabled
Port is untrusted
Extend trust state: not trusted [COS = 0]
Default COS is 0
7606-1#
12-19-2012 02:52 AM
Dears
Another strange thing
when mls qos is enabled
7600-PE1#sh mls qos queuing interface te2/1
Weighted Round-Robin
Port QoS is enabled
Port is untrusted
Extend trust state: not trusted [COS = 0]
Default COS is 0
7600-PE1#
when mls is disabled
7600-PE1#sh mls qos queuing interface te2/1
Weighted Round-Robin
QoS is disabled globally
Trust state: trust DSCP
Extend trust state: not trusted [COS = 0]
Default COS is 0
7600-PE1#
Any explanation please
Thanks
12-20-2012 05:03 AM
Any ideas
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: