cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
667
Views
0
Helpful
1
Replies

Etherchannel configuratio betwenn SWITCH VSS and ISR Router

habouzyad
Level 1
Level 1

Hello all,

I have in my data cneter the following :

1- Two Switchs 45XX configured AS VSS.  

2- We have a vlans configured and each vlans has its own SVI.

3- ISR ROUTER with 2 interface G.

 

We want connect this router to the both Swithcs using etherchannel (LACP). This Router will be connected to vlan ( exemple vlan2). This router must have an ip addresse on the VLAN2.

Would somoene help to did this configuration.

 

Thank you in advance

Best regards

CHAM

 

1 Reply 1

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

You can just connect the router with 2 interfaces (one to each VSS chassis) (no PO) and use 2 /30 subnets with routed ports on the 45xx VSS.

HTH

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco