Hello All. I can't seem to make a good loopback plug. I've tried four so far and none worked on a Cisco 1941 router switch or Gig ports, Dell laptop, Cisco small business switch ports, or Brocade switch ports. I've done pins 1 to 4 and 2 to 5, no luck.
I've done pins 1 to 3 and 2 to 6, no luck.
I've done pins 1 to 3, 2 to 6, 4 to 7, and 5 to 8, no luck.
Should I be inserting the wires from the clip facing up towards me? I'm solid when it comes to making straight, crossover, or rollover cables, but I'm obviously missing something. Any ideas or experiences? Thanks.
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...
good morning I have this report from users, saying that they encounter connection issue only when they are wired , but the wireless I fine. both connection are using the same path to the internet ...please advised a troubleshooting plan.
Enterprise Switching Business Unit is glad to announce Beta release 16.12.3 for all Catalyst 9200/9300/9400/9500/9600. This release is made available to allow users to test, evaluate and share feedback before General Avail...