07-07-2012 06:27 AM - edited 03-07-2019 07:38 AM
Hi,
I am working the EVN design but i am facing problem in the route replication (router leaking in VRF). I also read some cisco docs but did not get the
result.
Kindly look at below config and correct if there is any improper config
any example for EVN is helpful
vrf definition green
vnet tag 20
rd 2:2
!
address-family ipv4
route-replicate from vrf red unicast ospf 10
exit-address-family
!
vrf definition red
vnet tag 10
rd 1:1
!
address-family ipv4
route-replicate from vrf green unicast ospf 20
exit-address-family
interface Vlan10
vrf forwarding red
ip address 192.168.10.1 255.255.255.0
end
!
interface Vlan20
vrf forwarding green
ip address 192.168.20.1 255.255.255.0
end
router ospf 10 vrf red
network 192.168.10.0 0.0.0.255 area 0
!
router ospf 20 vrf green
network 192.168.20.0 0.0.0.255 area 0
07-07-2012 08:27 AM
Hi,
Try following the config guide. it has examples:
http://www.cisco.com/en/US/docs/ios-xml/ios/evn/configuration/xe-3s/evn-overview.html
HTH
07-07-2012 11:23 PM
Thanks for reply Reza
I am looking for any document which explain Route Replication. The above document is introduction of EVN with some initial commands.
Fazal
07-08-2012 03:13 AM
I edited the config.....to make it simple...
Any solution on it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide