FP1010 in ASA mode trunk configuration

[bruce.thornton]

I have a FP 1010 running ASA mode. I need to connect the FP1010 to a cable modem for a remote site to support PC/Phones. My plan is to configure a trunk on the inside interface of the FP 1010 and connect that to a trunk port on a Cisco switch to pass 2 vlans, (data/voice). My question is does teh FP1010 in ASA mode support this configuration? If yes config example please.

[balaji.bandi]

If this is ASA code running, we should use same ASA config as example below :  (hope is this what you looking if not please explain?)

https://www.petenetlive.com/KB/Article/0001085

On switch side you make a Trunk port and allow respected VLAN in theTrunk. (bottom onf the page there is link, if you click you get switch trunk example)