01-02-2007 10:50 PM - edited 03-05-2019 01:33 PM
how do i do a hard reset for my 4506 ?
tried some TACACS configuration on the 4506 but end up the config was messed up.
now i cant even go to global config mode when i telnet in.
since i cant go to global config mode, i cant do a erase startup-config.
01-02-2007 11:11 PM
if you are not able to get into privilege mode, then you need to follow password recovery procedure. During the process you can either reset the configuration or undo the changes you have done.
check this URL to get complete information.
hope it helps ... rate if it does ...
01-04-2007 09:36 PM
managed to get into rommon to reset the config of this 4506.
prob solved.
01-02-2007 11:12 PM
Hi
Hope this link helps.
regds
01-02-2007 11:23 PM
Hi,
If you have configured your Local username and Pwd configured and you know it , then try removing the switch from network , so that tacacs server is not reachable and it goes to the next level local if configured by you " no aaa new-model " and put a valid tacacs config.
Hope this helps
regards
vanesh k
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: