cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1707
Views
0
Helpful
2
Replies
Highlighted

Help Catalyast 2960G IOS deleted!!!

Ok, I have this 2960G switch that is used for practice. but one of my fellow class mates deleted the whole configuration in the switch, is their any way to put it in to ROMmon mode to get the IOS back on the switch? any help would be deeply appreciated.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Ok, I have this 2960G switch that is used for practice. but one of my
fellow class mates deleted the whole configuration in the switch, is
their any way to put it in to ROMmon mode to get the IOS back on the
switch? any help would be deeply appreciated.

Hi,

Check out the below link hope that help

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

If helpful do rate the post

Ganesh.H

View solution in original post

2 REPLIES 2
Highlighted

Ok, I have this 2960G switch that is used for practice. but one of my
fellow class mates deleted the whole configuration in the switch, is
their any way to put it in to ROMmon mode to get the IOS back on the
switch? any help would be deeply appreciated.

Hi,

Check out the below link hope that help

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

If helpful do rate the post

Ganesh.H

View solution in original post

Highlighted

Thanks it worked PERFECTLY!!!

Content for Community-Ad