11-20-2011 11:47 PM - edited 03-07-2019 03:30 AM
Hi.I'm doing a lab where I have to give a router an IP address In a zero subnet.I receive a bad mask error from the CLI and so I assume the no ip subnet-zero command Is In effect.
Is there any way to see If subnet zero Is enabled other than this ?
Thankyou
Solved! Go to Solution.
11-20-2011 11:50 PM
In all the latest IOS releases, ip subnet-zero is by default enabled.
So, in running-config; if you don't see ip subnet-zero; it has been removed then.
HTH,
Smitesh
11-20-2011 11:49 PM
Router# sh run | i subnet-zero
ip subnet-zero
11-20-2011 11:50 PM
In all the latest IOS releases, ip subnet-zero is by default enabled.
So, in running-config; if you don't see ip subnet-zero; it has been removed then.
HTH,
Smitesh
11-21-2011 01:24 AM
Ok.Thanks to you both! I was confused because I couldn't enable It on packet tracer.
11-21-2011 02:08 AM
Hi,
If your concern is addressed, can you please close this thread; so that other member doesn't waste their valuable time coming to this post and finding it already answered.
Regards,
Smitesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide