How to change hold-down timer of bfd echo mode on cisco nexus 7k?

[Herman2018]

Hi, How to change hold-down timer of bfd echo mode on cisco nexus 7k? the hold-timer is still 6s for echo mode when  the command "bfd interval 50 min_rx 50 multiplier 3" is configured on the interface ?  anyone please advise, thanks in advance!

[balaji.bandi]

Can you post the config bit and output ? (what nexus code running ?)

[Herman2018]

Thanks Babaji for your response!

The configuration for bfd is shown as below. (bfd echo mode)

1. interface xxxx

      ip ospf bfd

      no ip redirects

     ip ospf network point-to-point

   bfd interval 50 min_rx 50 multip 3

2. router ospf 1

      bfd

[MHM Cisco World]

I will run lab and check the value. 

[MHM Cisco World]

I run lab and I see hoddown (hits) always 0 (0) except the case the BFD is missing then the holddown will start count. 
so can I see 
show bfd neighbor detail 

[Herman2018]

Hi MHM,, what you describe about holddown (hit) is correct. but my question is the value of the holddown under echo mode. We set the bfd hello /tx interval and min_rx interval to 50 , and multiplier is set to 3. finally this values are shown as below: the holddown value is 6000ms (6s), but hello interval is 50ms with multiplier 3, then how bfd works to judge the failure? 3 hello packets : 50ms x 3? Please advise, thanks. 

10.x.y.z 10.a.bc.c  1124073773/1107296258 Up 5070(3) Up Eth1/18 default SH

Session state is Up and using echo function with 50 ms interval

Session type: Singlehop
Local Diag: 0, Demand mode: 0, Poll bit: 0, Authentication: None
MinTxInt: 50000 us, MinRxInt: 2000000 us, Multiplier: 3
Received MinRxInt: 50000 us, Received Multiplier: 3
Holdown (hits): 6000 ms (0), Hello (hits): 50 ms (872429985)
Rx Count: 21781382, Rx Interval (ms) min/max/avg: 0/1809/1743 last: 929 ms ago
Tx Count: 872429985, Tx Interval (ms) min/max/avg: 43/43/43 last: 5 ms ago
Registered protocols: pim ospf