cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

how to check hardware config of Cisco router/switch

wayne_fan
Beginner
Beginner

I need to check the interface card detail of a Cisco router, what command can be used? For Juniper, it's convenient with command "show chassis hardware", what's the Cisco equivalant of this? thanks.

11 REPLIES 11

ericngimme
Beginner
Beginner

sho env

this command doesn't tell me the model details of interface card. I just need to know what kind of interface cards are in each slots. thanks.


@wayne_fan wrote:

this command doesn't tell me the model details of interface card. I just need to know what kind of interface cards are in each slots. thanks.


How about - 

 

show module [ module-number | fex [ chassis_ID | all ]]
show hardware internal
show hw-module all
switch# show module
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ---------------------- ------------
1 40 40x10GE/Supervisor N5K-C5020P-BF-SUP active *
2 6 6x10GE Ethernet Module N5K-M1600 ok
3 8 8x1/2/4G FC Module N5K-M1008 ok
 
Mod Sw Hw World-Wide-Name(s) (WWN)
--- -------------- ------ --------------------------------------------------
1 4.2(1)N2(1) 1.3 --
2 4.2(1)N2(1) 0.100 --
3 4.2(1)N2(1) 0.200 20:81:00:0d:ec:e7:df:40 to 20:88:00:0d:ec:e7:df:40
 
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
1 000d.ece7.df48 to 000d.ece7.df6f JAF1344BHNK
2 000d.ece7.df70 to 000d.ece7.df77 JAB1228018M
3 000d.ece7.df78 to 000d.ece7.df7f JAB1231020C
switch#

switch# show module 2
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ---------------------- ------------
2 6 6x10GE Ethernet Module N5K-M1600 ok
 
Mod Sw Hw World-Wide-Name(s) (WWN)
--- -------------- ------ --------------------------------------------------
2 4.2(1)N2(1) 0.100 --
 
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
2 000d.ece7.df70 to 000d.ece7.df77 JAB1228018M
switch#

 

Farrukh Haroon
Engager
Engager

show diag

Regards

Farrukh

vaisharm
Cisco Employee
Cisco Employee

Hi,

'show diag' is the command.

HTH

~Vaibhav