11-06-2008 07:40 PM - edited 03-06-2019 02:21 AM
I have setup redundancy on my cat 6509 with dual sup720s
in the cat 6500 configuration guide
it states:-
Supervisor engine switchover takes place after the failed supervisor engine completes a core dump. A core dump can take up to 15 minutes. To get faster switchover time, disable core dump on the supervisor engines
how is this done? I cannot find the command to disable a core dump
11-07-2008 01:13 AM
Hi,
just type command "no exception dump" or
"no exception flash".
Check for any " execption" command in your running config and just disable it using the "no " form.
-amit singh
11-07-2008 05:04 PM
Amit,
thanks for your prompt reply, I have checked it out as per your response
regards
Richard
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide