06-14-2019 08:46 AM
I have Interface 25 on a Cisco SW350 Switch configured as follows:
fhg#show run interface gigabitethernet25
interface GigabitEthernet25
description FHG-KIN-FW01-FE2
port security max 10
no spanning-tree portfast
switchport access vlan 119
switchport trunk allowed vlan 1,119
no macro auto smartport
!next command is internal.
macro auto smartport dynamic_type unknown
!
How to i disable the Macro on this Interface Port 25 ?
06-14-2019 09:37 AM
- You may try defaulting the interface (default int x/y) and (only) apply the needed configuration commands again.
M.
06-14-2019 09:44 AM
Dear Marce,
I already tried Defaulting it by typing the following commands on the CISCO SG350-28P Switch by typing the following commands:
config t
default interface gigabitethernet25
But it gives an error "Unrecognized command".
06-14-2019 09:49 AM
Dear Marce,
I already tried Defaulting it by typing the following commands on the CISCO SG350-28P Switch by typing the following commands:
config t
default interface gigabitethernet25
But it gives an error "Unrecognized command".
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide