08-01-2014 10:45 AM - edited 03-07-2019 08:14 PM
Hi All.
How to enable LLDP on Cisco Catalyst 6500?; enable this feature has an impact?
Thank you.
Solved! Go to Solution.
08-01-2014 11:11 AM
Hey,
Its enabled by default. check the link below:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/power_over_ethernet.html#wp1116393
HTH.
Regards,
RS.
08-01-2014 12:50 PM
Hey,
Configure "lldp run" command in global configuration mode to enable it. And i don't believe there are any impacts enabling this feature unless you have too may PoE devices using lldp and less power available in PS unit.
HTH.
Regards,
RS.
08-01-2014 11:11 AM
Hey,
Its enabled by default. check the link below:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/power_over_ethernet.html#wp1116393
HTH.
Regards,
RS.
08-01-2014 12:02 PM
Hi Rajeevsh.
My switch has disable the lldp:
CORE#show lldp neighbors
% LLDP is not enabled
if i enable this feature has an impact?
Thank you.
08-01-2014 12:50 PM
Hey,
Configure "lldp run" command in global configuration mode to enable it. And i don't believe there are any impacts enabling this feature unless you have too may PoE devices using lldp and less power available in PS unit.
HTH.
Regards,
RS.
08-01-2014 12:01 PM
Hi Rajeevsh.
My switch has disable the lldp:
CORE#show lldp neighbors
% LLDP is not enabled
if i enable this feature has an impact?
Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide