12-03-2021 07:57 AM - edited 12-03-2021 08:04 AM
the problem start after table 6.3.It should say request time out but i got destination are unreachable i already make a new one almost 2 time but still facing the same problem.And when i try to skip it,i stuck at step 17.thera are no ip nat display.can someone fix my problem.I have to send my this assignment in a few days.
https://drive.google.com/file/d/12Fuwe74Q0Nw-j46OwK-TsoQ_mtNiWt-1/view?usp=sharing (my file)
12-03-2021 08:33 AM
Hello,
post the zipped Packet Tracer project (.pkt) file...
12-03-2021 05:44 PM - edited 12-03-2021 05:48 PM
12-04-2021 01:16 AM
Hello,
the main problem was the DHCP pool on the ISP router (network 127.0.0.0/8 instead of 128.0.0.0/8) which caused the Home router not to get an IP address at all.
I have also added the NAT configuration to to the Home router.
There is a typo in the instructions: At item 15., it says you should configure 'access-list 1 permit' followed by the suggested wildcard mask, 0.0.0.255. Since the actual Z network has a /16 mask, the correct wildcard mask must be 0.0.255.255.
Sometimes they build these 'mistakes' in in order to get you thinking. Either way, it might be a good idea to tell your instructor about it.
Attached the revised file (saved in Packet Tracer version 8).
12-04-2021 06:47 AM
FIXED,THANK YOU SO MUCH FOR THE HELP
12-04-2021 11:26 AM
Hello,
glad to help !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide