03-12-2013 11:28 AM - edited 03-07-2019 12:12 PM
Hi,
I try to remplace WLC because the old wlc (7.0) is capacity full...
but the AP (3502) do not "registered" to new WLC (7.3)....
If you have a idea, without make a reset factory to AP...
Best regards
03-12-2013 12:09 PM
You will need to update option 43 to point to the new WLC on the DHCP server subnet that serves the VLAN that the new AP is in.
03-12-2013 12:28 PM
Just change the ip address of where the AP is pointed to the new primary controller address . It should then reassociate to the new controller .
03-12-2013 12:43 PM
Go To WLC
Then Select Wireless
Select AP
Select High availability Tab
There will be Primary and Secondary Controller
If you want you app to select Primary Controller give that ip
and if u want to assing secondary controller give that ip.
*** Do Rate Helpful Posts***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide