cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
414
Views
0
Helpful
2
Replies
Highlighted
Beginner

How to print how much traffic goes in different queues when using mls

Hi,

What command should I use to see how much outgoing traffic is in different queues, when using mls qos?

interface GigabitEthernet3/1

no ip address

wrr-queue bandwidth percent 18 80 2

wrr-queue cos-map 3 1 1

wrr-queue cos-map 3 2 6 7

mls qos trust dscp

Thanks Niklas

Everyone's tags (3)
2 REPLIES 2
Highlighted
Participant

Re: How to print how much traffic goes in different queues when

Cisco IOS commands, such as show queue and show priority can help you to verify queueing.

Highlighted
Beginner

Re: How to print how much traffic goes in different queues when

Hi Again.

Some clarification

I am looking after a command that has same function as "show policy interface" for MQC supported cards.

I'm using 12.2 SRE software on a 7600 chassis.

//Niklas

Content for Community-Ad