Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Trying to setup rip over a l2tp tunnel (ipsec).In the other end I have a windows machine that using the rip listener.Can't get it work.Should it work?Have any some one any ideas how I should do the config?//Niklas
Hi,Have an issue that I can't fin the reason for.We have 10 spa942 phones.Some time the phones sending a bye message directly after you have answer the call.It happens approx 5 of 100 incoming calls.Has someone any clue why?Could it be any parameters...
HiHave following issueInstead of displaying the user's calling ID, the group number shall be displayed instead.Our sip proxy is fixing this.When I had done that, the problems started.The spa942 will not longer response on the 200 OK.Thats means that ...
Hi,Have a question:Have a numbers SPA942 with a group number and a DID number.If I want to make a call transfer between two phones, I must dial the full number to the C-user. reason is that the A-part comes from the PSTN gateway.Is it possible to co...
Hi,What command should I use to see how much outgoing traffic is in different queues, when using mls qos?interface GigabitEthernet3/1 no ip address wrr-queue bandwidth percent 18 80 2 wrr-queue cos-map 3 1 1 wrr-queue cos-map 3 2 6 7 mls qos trust...
Hi,Here is a trace.Grateful for any help//Niklasinput: sip_03880_20110411035342.pcapmatch: 4166325e-be1d174-148e50d6-26b3@sip-gw.abc.netU 2011/04/11 08:27:40.203539 w.w.w.w:5060 -> q.q.q.q:5060INVITE sip:222222222@ser.srv.ip-only.net;user=phone SIP/2...
HI again,Have started the debug function in the phone.I got following syslog message after receiving 200 OK02-05-2011 12:09:20 Local2.Debug 192.168.85.4 TP Parser error: 6Has someone any ideas?Will only get this error when a-number has been modified ...
Hi again,Have very stupid question.Have added following dial plan : (<100:123456789100>| (<101:123456789101>|The problem is that I can't call any other number, should I add the default part also ?(*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxx...
