08-09-2016 07:48 AM - edited 03-08-2019 06:55 AM
How do you see the reliability, rxload and txload on a L3 VLAN (SVI)? If you #sh int it only shows that info for physical interfaces, not VLANS. On a 9k that is connected I'm seeing a saturated VLAN but I don't know what is happening on my 5k.
08-12-2016 09:59 AM
how about "show interface vlan X counter". i know it doesnt show the rate but it will show the counters.
08-13-2016 01:09 AM
Could you please share sh int vlan #.
Also TX and RX on a SVI interface is logical and if it is showing more than the BW configured, it does not indicate a problem since it is just logical and not bound by the BW seen on it.
Regards,
Madhu.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide