07-05-2017 11:48 AM - edited 03-08-2019 11:13 AM
Hello
I'm trying to configure our new Cisco WS-C3850-48T-L switches, but HSRP is not supported because I have not stanby command.
What can I do to activate HSRP and more Layer 3 features
Here is version configured
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ------------------- ------------------ ------------
* 1 56 WS-C3850-48T 03.06.05E cat3k_caa-universalk9 INSTALL
License Level: Lanbase
License Type: Permanent
Next reload license Level: Lanbase
Thank you for any help
Solved! Go to Solution.
07-05-2017 12:08 PM
Hi,
You need IP Base or IP services license installed. With IP base you get basic layer-3 and HSRP and with IP services, you get full layer-3.
HTH
07-05-2017 12:08 PM
Hi,
You need IP Base or IP services license installed. With IP base you get basic layer-3 and HSRP and with IP services, you get full layer-3.
HTH
07-06-2017 01:43 AM
Thank you for your response
What vesion of IOS XE I should install to have Ip base or Ip service on WS-C3850-48T-L? The actual image on my switches is cat3k_caa-universalk9 version 03.06.05E .
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide