HSRP configuration on cisco WS-C3850-48T-L

[mamadou.barry]

Hello

I'm trying to configure our new Cisco WS-C3850-48T-L switches, but HSRP is not supported because I have not stanby command.

What can I do to activate HSRP and more Layer 3 features

Here is version configured

Switch    Ports      Model SW        Version          SW Image                        Mode
------ ----- ----- ---------- ---------- -------------------    ------------------                  ------------ 
* 1      56           WS-C3850-48T   03.06.05E     cat3k_caa-universalk9    INSTALL

License Level: Lanbase
License Type: Permanent
Next reload license Level: Lanbase

Thank you for any help

[Reza Sharifi · Accepted solution]

Hi,

You need IP Base or IP services license installed.  With IP base you get basic layer-3 and HSRP and with IP services, you get full layer-3.

HTH

[mamadou.barry]

Thank you for your response

What vesion of IOS XE I should install to have Ip base or Ip service on WS-C3850-48T-L? The actual image on my switches is cat3k_caa-universalk9   version 03.06.05E .

Thanks