cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Ask the Expert- SD-WAN

372
Views
0
Helpful
2
Replies
Highlighted
Beginner

HSRP Disabled SWitch L3 4507

Hi, i have a network with redundancy HSRP between my two cores, but  one of them 

it stopedd working. does not recongnize standby commands, i try to enable with standby console enable command but it does not work. 

 

the configuration in the switch is the following:

 

 

SOLCL-CORE1-TI#sh module

Chassis Type : WS-C4507R+E

Power consumed by backplane : 40 Watts

Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 48 10/100/1000BaseT EEE (RJ45) WS-X4748-RJ45-E CAT1625L1SR
2 12 10GE SFP+ WS-X4712-SFP+E CAT1629L16E
3 4 Sup 7-E 10GE (SFP+), 1000BaseX (SFP) WS-X45-SUP7-E CAT1809L3A0

M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 d48c.b5e1.6ee0 to d48c.b5e1.6f0f 1.1 Ok
2 a493.4c5f.5548 to a493.4c5f.5553 1.1 Ok
3 30f7.0d06.6700 to 30f7.0d06.6703 2.1 15.0(1r)SG5 03.04.06.SG Ok

Mod Redundancy role Operating mode Redundancy status
----+-------------------+-------------------+----------------------------------
3 Active Supervisor RPR Active


SOLCL-CORE1-TI#sh redundancy
Redundant System Information :

------------------------------
Available system uptime = 41 weeks, 5 days, 22 hours, 23 minutes
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none

Hardware Mode = Simplex
Configured Redundancy Mode = RPR
Operating Redundancy Mode = RPR
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode

Current Processor Information :
------------------------------
Active Location = slot 3
Current Software state = ACTIVE
Uptime in current state = 41 weeks, 5 days, 22 hours, 22 minutes
Image Version = Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (c
at4500e-UNIVERSALK9-M), Version 03.04.06.SG RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2015 by Cisco Systems, Inc.
Compiled Mon 04-May-15 02:44 by prod
BOOT = bootflash:cat4500e-universalk9.SPA.03.04.06.SG.151-2.SG6.bin,12;
Configuration register = 0x2102

Peer (slot: 4) information is not available because it is in 'DISABLED' state

2 REPLIES 2
VIP Advisor

Re: HSRP Disabled SWitch L3 4507

how about other side show output and Post HSRP configuration both the Cores

BB
*** Rate All Helpful Responses ***
Enthusiast

Re: HSRP Disabled SWitch L3 4507

Are you referring to SSO i.e redundant supervisor or HSRP ?
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards