10-17-2014 01:42 PM - edited 03-07-2019 09:10 PM
We have a 4507R+E with dual Sup7-E's running IOS 15.1(2) SG4. The license level is LANBase. I am creating the initial configurations for the switch but cannot change the uplink state of the SFP ports on the supervisors. I tried to run the command HW-MODULE UPLINK SELECT but it is not present. These are the only option available under HW-MODULE.
switch(config)#hw-module ?
module Specify a linecard slot for the hw-module command
slot Specify a linecard slot for the hw-module command
system Specify the system parameter
Is this a license restriction?
Solved! Go to Solution.
10-17-2014 11:04 PM
On a 4507R+E, "hw-module uplink select all" is enabled by default, however, because you've got redundant Sup card, the uplink ports 3 & 4 are disabled permanently.
This is because the backplane speed of the chassis is 48 Gbps. So you can only use up to four (4) 10 Gbps interfaces.
10-17-2014 11:04 PM
On a 4507R+E, "hw-module uplink select all" is enabled by default, however, because you've got redundant Sup card, the uplink ports 3 & 4 are disabled permanently.
This is because the backplane speed of the chassis is 48 Gbps. So you can only use up to four (4) 10 Gbps interfaces.
10-17-2014 11:04 PM
LEO--PM
10-17-2014 11:27 PM
Got it. :)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: