02-01-2013 10:50 AM - edited 03-07-2019 11:27 AM
Hello,
I am trying to review the port-channel configuration on a 6500 series. I am issuing the "show etherchannel summary" command and the out put shows the Group, Port-Channel, and Ports. It does not show me the protocol that is in use such as PAgP or LACP. Does this have to do with the Etherchannel in the "On" mode rather than "active", or "Auto"?
Thank you
02-01-2013 11:20 AM
Hi,
yes you're correct this etherchannel doesn't use either protocol as it is in on mode.
Regards
Alain
Don't forget to rate helpful posts.
02-01-2013 11:24 AM
You can gather the information you are looking for from the mode of the etherchannel.
Auto and Desirable means it is using PaGP.
Active or Passive means it is using LACP
ON means it is not using any negotiation protocol
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: