i cant put route map on the interface

[rgaleana06]

                   i have a tack the siwtche and i cant put a route map in the interface vlan

can you help me please, i have this ios in my stack

1 26    WS-C3750-24P       12.2(55)SE3           C3750-IPBASEK9-M

2 26    WS-C3750-24P       12.2(55)SE3           C3750-IPBASEK9-M

3 28    WS-C3750G-24PS     12.2(55)SE3           C3750-IPBASEK9-M

4 28    WS-C3750G-24PS     12.2(55)SE3           C3750-IPBASEK9-M

5 54    WS-C3750X-48P      12.2(55)SE3           C3750E-IPBASEK9-M

an i try to put this configuration

interface Vlan181

ip address 192.168.181.2 255.255.255.0

ip policy route-map name

[paul driver]

Hello

What sdm template are you using- i think you need the routing template to apply PBR

sh sdm prefer

conf t

sdm prefer routing

you will need to reload stack for this to take affect.

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

[rgaleana06]

The current template is "desktop default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.

  number of unicast mac addresses:                  6K
  number of IPv4 IGMP groups + multicast routes:    1K
  number of IPv4 unicast routes:                    8K
    number of directly-connected IPv4 hosts:        6K
    number of indirect IPv4 routes:                 2K
  number of IPv4 policy based routing aces:         0
  number of IPv4/MAC qos aces:                      0.5K
  number of IPv4/MAC security aces:                 1K

[paul driver]

Hello

So to apply policy based routing via route-map the sdm template needs to be "routing"

res

Paul

Please don't forget to rate any posts that have been helpful.

Thanks.

[rgaleana06]

i do it this procedure but i have the same problem

[cadet alain]

Hi,

did you reload the switch for the new SDM template to take effect ?

Regards

Alain

Don't forget to rate helpful posts.

[alessandro.s]

Hi Ricardo,

i think you have to run at least an IPSERVICE IOS to achieve this command. Your switches are all running IPBASE IOS.

Hope this helps.

Regards

[cadet alain]

Hi,

Good catch 

Regards

Alain

Don't forget to rate helpful posts.

[alessandro.s]

Thanks!!

just too simple for you!

Regards

Alessandro