I have 2 IE2000-8TC-G-E devices that I wish to HSRP between, issue being i dont seem to have available all the subset of the standby command.
They are both lanbase, if i set the below on a port, i get the standby command available:-
no switchport ip address 192.168.99.2 255.255.255.0
BUT when trying the standby command I do not get any of the IP subset of teh command available, if i try standby 1 ip 192.168.99.1 for example, i get ip unknown command, only options are showne below.
SwitchA(config-if)#standby ? <0-255> group number authentication Authentication delay HSRP initialisation delay follow Name of HSRP group to follow mac-refresh Refresh MAC cache on switch by periodically sending packet from virtual mac address name Redundancy name string preempt Overthrow lower priority Active routers priority Priority level redirect Configure sending of ICMP Redirect messages with an HSRP virtual IP address as the gateway IP address timers Hello and hold timers track Priority tracking version HSRP version
SwitchA(config-if)#standby 1 ? authentication Authentication follow Name of HSRP group to follow name Redundancy name string preempt Overthrow lower priority Active routers priority Priority level timers Hello and hold timers track Priority tracking