Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1335
Views
0
Helpful
1
Replies

IE2000U boot loop

rex.baker
Level 1
Level 1

‎02-15-2017 10:04 PM - edited ‎03-08-2019 09:21 AM

I have an IE 2000U that continually boots to the boot loader prompt. If I re-copy the IOS/image to the sd card, then power on the IE 2000, it will boot once.

However, at that point, if I do a "sh flash:" command, the flash shows as being empty. Even if I reformat the sd flash and tftp a new copy of the IOS to the flash, as soon as I reload the IE 2000U, it boots back to the boot loader prompt and shows the flash as empty.

I suspect that this is a boot loader issue. 

Does anyone know how to force an IE 2000U to reload its bootloader file?

Rex.

2 people had this problem
Labels:
0 Helpful
1 Reply 1

Yashas Bhadoria
Cisco Employee
Cisco Employee

‎02-28-2017 11:11 PM

1.Try downloading the latest firmware and then try to update.

2.For Flash try using an USB flash to load the IOS.

Then try formatting and use the sync command to copy all files to flash and usb flash

3.For Flash related commands please refer the following guide:

http://www.cisco.com/c/dam/en/us/td/docs/switches/lan/cisco_ie2000/hardware/sd-card/sd_card.pdf

4.If the issue persists contact TAC

0 Helpful
Customers Also Viewed These Support Documents