Solved: Re: Industrial Switches IE 1000 Command line

arun panengal · ‎12-19-2021

Not able to get the the normal commands like config terminal and all to do the switch configuration through CLI.

Attaching the list of command available in the switches.

Georg Pauwen · ‎12-20-2021

Hello,

not sure if you are in a position to get a different firmware image, but I have been looking at the thread linked below, and it appears that some versions actually do have a CLI:

https://community.cisco.com/t5/switching/ie-1000/td-p/3335060

View solution in original post

marce1000 · ‎12-20-2021

- Ref : https://www.cisco.com/c/en/us/products/collateral/switches/industrial-ethernet-1000-series-switches/datasheet-c78-737277.html

>.... Manageability: Web GUI interface, and diagnostics and analysis options through Simple Network Management Protocol (SNMP) and syslog

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

arun panengal · ‎12-20-2021

Thanks @marce1000 .And there is no way to configure the switches through CLI. If possible , help me with command list .

Georg Pauwen · ‎12-20-2021

Hello,

not sure if you are in a position to get a different firmware image, but I have been looking at the thread linked below, and it appears that some versions actually do have a CLI:

https://community.cisco.com/t5/switching/ie-1000/td-p/3335060