10-28-2009 02:57 AM - edited 03-06-2019 08:20 AM
Hi,
I have a doubt and I don't know if this possible.
Can I install a DSP (PVDM) from a 2600 series router into a 2600xm series router?
Regards
10-28-2009 08:08 AM
Hello Antonio,
you have a PVDM or PVDM2?
two different generations of DSPs exist for cisco routers so your question is wise.
Hope to help
Giuseppe
10-28-2009 08:12 AM
Thank you for your response Giussepe.
Sincerenly, I don't know exactly how can I discover what type of PVDM I have?
Regards
10-28-2009 08:55 AM
'sh voice dsp'
Check out DSP TYPE in the output.
10-28-2009 08:57 AM
Hi,
I've already known it, but my problem is that the original router has crashed and I cannot execute this command.
If I connect this DSP, is there any risk?
Regards
10-28-2009 09:06 AM
I highly doubt you'll "fry" anything. If I were you I'd just try and see. Do you see any writing on the PVDM's at all?
10-28-2009 09:08 AM
When you tell "fry anything", what is anything?
PVDM?
Router?
Regards
10-28-2009 09:13 AM
Don't take my word for it but I doubt you'll ruin the router or the PVDM. Why don't you compare models on the DSP Calculator? http://www.cisco.com/cgi-bin/Support/DSP/cisco_configure.pl
You can plug in both of your router types and go from there.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide