01-06-2015 09:08 PM - edited 03-07-2019 10:07 PM
Hi Team,
Could someone please let me know why am I seeing the int vlan counter rate as 0??????
UK-Switch#sh run int g1/3
Building configuration...
!
interface GigabitEthernet1/3
description uk
switchport
switchport access vlan 120
switchport mode access
spanning-tree portfast edge
spanning-tree bpduguard enable
channel-group 1 mode active
end
UK-Switch#sh int vlan 120 | i rate
Queueing strategy: fifo
5 minute input rate 0 bits/sec, 0 packets/sec >>>>>>>>>>>> o bits input and output why?
5 minute output rate 0 bits/sec, 0 packets/sec
UK-Switch#sh int g1/3| i rate
Queueing strategy: fifo
5 minute input rate 123000 bits/sec,50 packets/sec
5 minute output rate 98000 bits/sec, 55 packets/sec
UK-Switch#sh int po1 | i rate
Queueing strategy: fifo
5 minute input rate 268000 bits/sec, 100 packets/sec
5 minute output rate 232000 bits/sec, 120 packets/sec
thanks
01-07-2015 07:59 AM
Because most normal traffic is routed in hardware and not routed to the CPU (SVI) to be routed so you conceivably might not see much traffic punted to the CPU .
01-07-2015 08:12 AM
If there is a routing through Vlan 120, then you MUST see input and output counters for the Vlan interface.
That means, no routing for Vlan 120 exist.
Regards,
Mohamed
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: