cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10930
Views
0
Helpful
5
Replies

Invalid next hop address, it belongs to one of our interfaces

bjoern.sommer
Level 1
Level 1

Hello Cisco-Experts 

I have a simple Problem :

[ERROR] route inside 0.0.0.0 0.0.0.0 192.168.1.1 tunneled
%Invalid next hop address, it belongs to one of our interfaces

Routing Now:

outside 0.0.0.0 0.0.0.0 89.246.xx.xx 1 None

192.168.1.1 = ASA-Router  

I have Setup VPN-SSL and its working 

I want tunnel all traffic over  VPN (no Split tunnling) for that i need a static route:

route inside 0.0.0.0 0.0.0.0 192.168.1.1 tunneled

But the ASDM say: %Invalid next hop address, it belongs to one of our interfaces

But why ? 

THX for any help 

5 Replies 5

cofee
Level 5
Level 5

Who owns 192.168.1.1? Just make sure next hop address is not configured on the firewall that's giving you error.

ok I understand so i must do this

route inside 0.0.0.0 0.0.0.0 89.246.xx.xx tunneled

but than he say :

You have another route configure for this network any4 which has same gateway. ....

The other one is :

outside 0.0.0.0 0.0.0.0 89.246.xx.xx 1 None

But i need both routes.

What can i do  ?

Please explain what you are trying to accomplish and how your network is set up. A small drawing will help, just want to see what the traffic flow is.

I hope you must have a switch/router connected to inside interface of the ASA and that device is acting as gateway to your internal network. If that's true then use below:

route inside 0.0.0.0 0.0.0.0 192.168.1.x tunneled

here 192.168.1.x should be the IP address of the switch/router Layer-3 interface which is directly connected to ASA. The error which you are getting is because you use ASA's interface IP (192.168.1.1) as next-hop

is it resolved ?

Review Cisco Networking for a $25 gift card