09-24-2012 11:57 AM - last edited on 03-25-2019 04:21 PM by ciscomoderator
Hi
I'm trying to configure "IP PIM SPARSE-MODE" command on a vlan interface on a 3560E switch but it doesn't give me the option to do this. The only option available is ip pim passive. What would cause this ? On the same switch a physical interface is already configured with IP PIM SPARSE-MODE.
Thanks
Solved! Go to Solution.
09-24-2012 02:26 PM
Hello Harry,
What license do you have running on your 3560E? I vaguely recall that a basic license or feature set for 3560E Catalysts supports only the PIM Stub routing which is why you see only the ip pim passive command. You would probably need to upgrade your license/feature set to get full multicast routing support.
Best regards,
Peter
09-24-2012 02:26 PM
Hello Harry,
What license do you have running on your 3560E? I vaguely recall that a basic license or feature set for 3560E Catalysts supports only the PIM Stub routing which is why you see only the ip pim passive command. You would probably need to upgrade your license/feature set to get full multicast routing support.
Best regards,
Peter
09-24-2012 02:45 PM
Thanks Peter. And looks like you are right . This artical explains it under PIM Stub routing
and the switch is running just ipbase so looks like a upgrade it in order. Thanks for you help.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide