IP SLA configuration

[tedauction]

Hello I have a Cisco CISCO1921/K9. I want to have this remote router measure packet loss back to my head office WAN interface 192.169.2.2.

I will use PRTG SNMP monitor to read the results of the IP SLA from the Cisco. Could someone please help with a basic configuration via IP SLA for this ?

These are the commands I initially have available:

myRouter1(config)#ip sla ?
key-chain Use MD5 Authentication for IP SLAs Control Messages
responder Enable IP SLAs Responder
server IPPM server configuration

Thank you kindly for any help.

[Philip D'Ath · Accepted solution]

A basic example.  However PRTG can do its own pings and measure the results ...

ip sla 1
  icmp-echo <ip address>
ip sla schedule 1 life forever start-time now

[Philip D'Ath · Accepted solution]

Oh I see the issue.  You need an "AX" licence to enable this feature.