08-21-2014 08:36 AM - edited 03-07-2019 08:29 PM
Hi All
I am trying to set up failover on my core switch
However when I put in the config I get the following %Entry not configured
ip route 0.0.0.0 0.0.0.0 10.88.11.151 name BACKUP-INTERNET track 11
track 11 ip sla 11 reachability
ip sla 11
ip sla schedule 11 life forever start-time now
ip sla enable reaction-alerts
Please help
Thanks
Solved! Go to Solution.
08-21-2014 11:18 AM
Hi,
If you are trying to configure IP SLA trcking, follow this document:
https://supportforums.cisco.com/document/30296/using-ipsla-change-routing
HTH
08-21-2014 01:01 PM
Your best bet would be to follow the doc Reza supplied to get a full understanding but, you might want to try adding:
"icmp-echo destination-ip source-ip source-ip"
You have the schedule configured but, your schedule doesn't have a probe(icmp-echo) yet.
Destination could be 8.8.4.4 or 4.2.2.2 (some reliable Internet address) and source could be a loopback or management ip of the switch
08-21-2014 11:18 AM
Hi,
If you are trying to configure IP SLA trcking, follow this document:
https://supportforums.cisco.com/document/30296/using-ipsla-change-routing
HTH
08-21-2014 01:01 PM
Your best bet would be to follow the doc Reza supplied to get a full understanding but, you might want to try adding:
"icmp-echo destination-ip source-ip source-ip"
You have the schedule configured but, your schedule doesn't have a probe(icmp-echo) yet.
Destination could be 8.8.4.4 or 4.2.2.2 (some reliable Internet address) and source could be a loopback or management ip of the switch
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide