01-11-2023 04:03 PM
Hi, on the OFG Book CCNA 200-301, Wendell Odom is saying that "Cisco IOS switches today typically default to using RSTP rather than STP".
But when i check a fresh boot of a Cisco IOS image from CML, in the running-config there is PVST mode and not RPVST.
So who is right here ?
Thank you.
01-11-2023 04:13 PM
for me, SW use IOS not IOS XE always use RSTP as default.
PVST or R-PVST is config not default
01-11-2023 04:23 PM
Hello,
This could have been updated after the book came out in print. I cannot think of a situation (even in the CISCO exams) where you would need to know which default Spanning-tree mode is enabled on an IOS device with regards to specific versions either. This could also be IOS version specific. You should know at the very least that PVST is CISCO proprietary and RSTP is open standard along with the features of each.
Hope that helps
-David
01-12-2023 07:22 PM
With a show version i have "Experimental Version 15.2", and i'm right by this Cisco IOS 15.2M&T - Retirement Notification - Cisco
It's an old version right ? If yes, it's a bit sad to get that from CML...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide