Is there CLI for viewing switchports with no activity in last 60 days

[adil.nasser3]

Hello

I am working on a request to clean up alot of excess cabling in one of our IDF's.  I noticed that many of the connections have no lights on them and probably haven't been used in a long while.  I would like to know if there is a CLI command I can run on the Cisco 3750 switch will allow me to bring up a list of ports which have not seen any activity for a period of time - for example, 30, 60, or 90 days.

Thank you,

Adil Nasser

[Leo Laohoo · Accepted solution]

sh int | i protocol | Last input

[adil.nasser3]

I was hoping for a more organized report but this command serve its purpose.  Thanks a bunch.

[Leo Laohoo]

Thank you very much for your consideration and rating.

If you had, for example, a 4500 switch then it's possible the command and output would be more "gentle".  But I still don't understand why the "sh interface link" (or similar) command wasn't or couldn't be ported to the rest of the Catalyst switches.