cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1070
Views
0
Helpful
1
Replies

LACP with 10GB interfaces between 3750X and 2960S switches

rezende.c
Level 1
Level 1

Hi all,

   I need to know if is possible to do a LACP using  2 x 10GB between 3750X and 2960S (WS-C2960S-48LPD-L) switches.

thanks,

Claudio

1 Reply 1

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Claudio,

LACP is listed in C2960 datasheet

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6406/product_data_sheet0900aecd80322c0c.html

However,

C2960 configuration guide says:

>>The EtherChannel provides full-duplex bandwidth up  to 800 Mbps (Fast EtherChannel) or 8 Gbps (Gigabit EtherChannel)  between your switch and another switch or host.

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_25_fx/configuration/guide/swethchl.html

So I'm not sure that the C2960 does not support bundling of the 10GE uplink ports.

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_25_fx/configuration/guide/swintro.html#wp1062296

>>

EtherChannel for enhanced fault tolerance and for  providing up to 8 Gbps (Gigabit EtherChannel) or 800 Mbps (Fast  EtherChannel) full-duplex bandwidth among switches, routers, and servers  

I would say bundling of the 10GE uplinks is not supported

Hope to help

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: