Hi all,
Looking my WLC Wireless Tab I noticed that almost all 2.4 radios are on the same channel.DCA is enabled on automatic mode but no change happen.I checked others sources of 2.4GHz but there is no strong signal near to cause this issue.Some radi...
Hi all,
I have a wlc 2504 (8.0.140) in my HQ and 1532 access points in my branch offices working in flexconnect+bridge (mesh) mode.
When happen a lost of comunication between branch office and HQ the access points not rejoin to WLC when the ...
Hi all,
In Cisco Wireless Flexconnection solution, can you tell me the difference between "Web Authentication ACL" and "Web Policy ACL" .
Regards,
Claudio Rezende
Hi All, I running a WLC with 4.2.0.5 software and AIR-LAP1252AG-T-K9 access points. After register in WLC the 802.11a radio not working and is showing as "not supported". What can be happing? My WLC is configured to use "US" contry code.help pl...
Guys,
Look that post. I have similar problems and found this. I will try the test yet.
https://supportforums.cisco.com/discussion/12543176/workaround-android-devices-do-not-roam-wifi
Regards,
Hi Faramir,
Did you solve this issue? I have similar problem.
I tried a lot of thinks like, user idle timeou, sleep client, increase eappol tiemout, etc..
Nothing work for Android 5.0 or later devices.
Regards,
Claudio Rezende
Hi Tyson,
- This is a Mesh network and I'm using 5GHz only for backhaul.
- I change some DCA configs. Look attached the actual config.
- 8.0.140
Thanks
Claudio