Hi All,
ok so my 350XG is all configured up and I need now to connect it to my existing (to be replaced) infrastructure.
So I configured the following;
interface TenGigabitEthernet1/0/7
description DELL-STACK-TEMP
switchport mode trunk
switchport trunk allowed vlan 200
I then configured a port on the XG as an access port on vlan 200 as below;
interface TenGigabitEthernet1/0/8
description Test
switchport access vlan 200
I then connected port 7 to my Dell 6224 (port 21) which I configured as a trunk port also
interface ethernet 1/g20
description "TEMP-CiscoXG"
mtu 9216
switchport mode general
switchport general pvid 200
switchport general allowed vlan add 200 tagged
exit
I've also tried configuring it,
interface ethernet 1/g20
description "TEMP-CiscoXG"
mtu 9216
switchport mode trunk
exit
I've hooked a laptop up to port 8 on the cisco (the access port) and given it an IP address of 192.168.200.210 /24. The gateway on the Dell for VLAN 200 is 192.168.200.254... I'm not able to ping anything from the laptop (including the gateway) and I can't ping the laptop from anything connected to the Dell switch....
Anyone any ideas what I'm doing wrong? I'm sure it's something daft!
thanks in advance,
Paul.
