Line 2 On Cisco 2911 router

[johnlloyd_13]

hi all,

i just noticed this section of the config.

can someone enlighten me what's this for?

line 2

no activation-character

no exec

transport preferred none

transport input all

transport output pad telnet rlogin lapb-ta mop udptn v120 ssh

stopbits 1

[Rejohn Cuares]

Line 2 in 2900/3900 series router is used by ISM.

You can verify this by issueing this command:

service-module embedded-Service-Engine X/Y status

Please rate replies and mark question as "answered" if applicable.

[Justinharris1]

I randomly check my 2900 established users line (sh users) and found today that my GW has "line 2" configured. I did not do this. There is no way to remove this?