06-04-2010 06:51 AM - edited 03-06-2019 11:25 AM
Ethernet0 is up, line protocol is down
Hardware is QUICC Ethernet, address is 0010.7bf2.3638 (bia 0010.7bf2.3638)
Internet address is 193.1.1.4/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 128/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:03, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
395 packets output, 25359 bytes, 0 underruns
395 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
395 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Solved! Go to Solution.
06-04-2010 07:00 AM
Hi,
Very good question without a question...!!!
Ethernet0 is up, line protocol is down
Hardware is QUICC Ethernet, address is 0010.7bf2.3638 (bia 0010.7bf2.3638)
Internet address is 193.1.1.4/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 128/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:03, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
395 packets output, 25359 bytes, 0 underruns
395 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
395 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
It is physical layer issue reliability is very low and Lost carrier denotes you have a bad cable or check the physical connections on both sides.
BTW, any luck with setting speed and duplex manually on both sides. ?
HTH
Hitesh Vinzoda
Pls rate useful posts
06-04-2010 06:57 AM
sorry forgot to say it is to connect to this ethernet port using cat5e cable.
The ethernet port setting from show interface command are :
Ethernet0/0 is up, line protocol is down
Hardware is AmdP2, address is 0008.21d9.e1c0 (bia 0008.21d9.e1c0)
Internet address is 192.168.1.1/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 128/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:02, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
192 packets output, 11818 bytes, 0 underruns
192 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
192 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
06-04-2010 07:00 AM
Hi,
Very good question without a question...!!!
Ethernet0 is up, line protocol is down
Hardware is QUICC Ethernet, address is 0010.7bf2.3638 (bia 0010.7bf2.3638)
Internet address is 193.1.1.4/24
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 128/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:03, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
395 packets output, 25359 bytes, 0 underruns
395 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
395 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
It is physical layer issue reliability is very low and Lost carrier denotes you have a bad cable or check the physical connections on both sides.
BTW, any luck with setting speed and duplex manually on both sides. ?
HTH
Hitesh Vinzoda
Pls rate useful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide