- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-04-2023 02:38 PM
Hey all,
Have a BE6000 running esxi 6.7.0 for CUCM. The Link Discovery Protocol option only has CDP. The BE6000 is currently connected to a Cisco C9300 switch, but I want to connect it to an Extreme 3750. I enabled CDP on the ports on the Extreme 3750 but there is no connectivity. Is it somehow possible to enable LLDP as an option? Or maybe there is some way I don't know to configure the Extreme Switch ports (current sharing config below).
enable sharing 1:13 grouping 1:13,2:13 algorithm address-based L2 lacp
Screenshot of vSwitch properties showing CDP as only option.
Solved! Go to Solution.
- Labels:
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-04-2023 04:14 PM
Hi,
Looking at the vSwitch CDP setting - You are in listen mode.
The vSwitch will not be sending CDP packets/imfo the the physical switch.
IMO you should set this to "Both" then you will be sending and recicving CDP info.
Look at this link.
https://kb.vmware.com/s/article/1003885
Hope this helps
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-04-2023 04:14 PM
Hi,
Looking at the vSwitch CDP setting - You are in listen mode.
The vSwitch will not be sending CDP packets/imfo the the physical switch.
IMO you should set this to "Both" then you will be sending and recicving CDP info.
Look at this link.
https://kb.vmware.com/s/article/1003885
Hope this helps
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-04-2023 04:26 PM
Thanks @acampbell will give that a try tonight.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-10-2023 04:50 PM
Changed the mode from Listen to Both and all good!
