cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2679
Views
5
Helpful
6
Replies

Loading IOS on ASR 1001 through MGMT interface?

jasosmith
Level 1
Level 1

I'm trying to copy code to an ASR 1001 using TFTP via the MGMT interface.  I have verified connectivity via ping and have set the tftp-source interface to Gig0 accroding to the Quick start guide.  However, when I try to copy the code from my PC to the ASR it times out.

Router#copy tftp: bootflash:                    

Address or name of remote host [10.0.0.2]?

Source filename [asr1001-universalk9.03.03.00.S.151-2.S.bin]?

Destination filename [asr1001-universalk9.03.03.00.S.151-2.S.bin]?

Accessing tftp://10.0.0.2/asr1001-universalk9.03.03.00.S.151-2.S.bin...

%Error opening tftp://10.0.0.2/asr1001-universalk9.03.03.00.S.151-2.S.bin (Timed out)

Config

ip tftp source-interface GigabitEthernet0

!

interface GigabitEthernet0

vrf forwarding Mgmt-intf

ip address 10.0.0.1 255.255.255.0

negotiation auto

Router#ping vrf Mgmt-intf 10.0.0.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds:
!!!!!

Thanks

Jason

6 Replies 6

Reza Sharifi
Hall of Fame
Hall of Fame

Check the PC or laptop for firewall software that might be blocking TFTP (port 69)

HTH

Yep, that was it!

I thought about that right after I posted the question.

For the record, you most certainly can load IOS from the MGMT interface.

js

Richard Burts
Hall of Fame
Hall of Fame

Reza got it right and gets my +5.

HTH

Rick

Sent from Cisco Technical Support iPhone App

HTH

Rick

Rick,

Thank you so much for the rating!!

Reza

Reza

I had the same thought but you beat me to it. I would hope that Jason would have rated your response. But since he did not it is the least I can do to acknowledge a correct response that led to a solution to the problem.

HTH

Rick

HTH

Rick

Leo Laohoo
Hall of Fame
Hall of Fame

You can also load the IOS via the USB port. 

Review Cisco Networking for a $25 gift card