12-03-2015 07:32 AM - edited 03-08-2019 02:57 AM
Hello,
I facing difficulties on my LAN.
I've a core 3850 stack, and 2960X access switches.
3850#show mac address-table | i 6d75
3 aaaa.bbb9.6d75 STATIC Gi1/0/5
3850#sh ip arp | i 6d75
Internet 192.168.34.108 0 aaaa.bbb9.6d75 ARPA Vlan3
3850#ping 192.168.34.108
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.34.108, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
3850#show mac address-table | i 6d75
3 aaaa.bbb9.6d75 DYNAMIC Po1
3850#sh int desc
Interface Status Protocol Description
Po1 up up ## Downlink to 2960 ##
2960#show mac address-table | i 6d75
3 aaaa.bbb9.6d75 STATIC Gi3/0/13
Here is the Gi1/0/5 port configuration :
interface GigabitEthernet1/0/5
description ## User Port ##
switchport access vlan 3
switchport mode access
switchport port-security maximum 8
switchport port-security
switchport port-security aging time 2
switchport port-security violation restrict
switchport port-security aging type inactivity
logging event link-status
no snmp trap link-status
storm-control broadcast level 5.00
storm-control action trap
spanning-tree portfast
spanning-tree bpduguard enable
end
Can you help me about that ?
Thanks
12-03-2015 07:47 AM
you can clear the mac address fom the table and arp once its moved , there is default timers in place for cam and arp tables on the switch and the mac exists at layer 2 in the broadcast domain for that vlan if its on on both switches
clear mac address-table dynamic address x.x.x
clear ip arp x.x.x.x
12-03-2015 07:56 AM
Hello
I agree with the cmds but even after 2 days the mac address stays in the table on old port, so I think automatic timers expired ?
12-03-2015 08:01 AM
timers are around 4 hours default for macs on Cisco kit , whats this oem switch that has the pc originally connected
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide